Home > KitchenAid > KitchenAid w11323304 Dishwasher

KitchenAid w11323304 Dishwasher

NOTE: Pre-tinned wires should not be used when connecting to  
the terminal block. Ensure black is aligned with black and white is  
aligned with white in the terminal block.  
24. Reinstall terminal box cover and wires  
Wire wrapped two-thirds around  
Wire wrapped three-quaters around  
Strip insulation and wrap wire  
Figure: 1  
Place wires inside terminal box. Replace the cover by inserting  
the hooks of the terminal cover into the slots in the floor of the  
terminal box and sliding the cover tight against the back wall  
where wires come in. Make sure wires are tucked inside the box  
and not pinched by the cover.  
Snug Contact  
Put the terminal box back on the crossbar and push to the right  
so terminal box snaps into the plastic side member.  
Contact Surface  
Screw Post  
NOTES:  
Do not plug cord into an outlet until instructed to do so.  
Once the terminal box has been remounted on the dishwasher,  
tuck any excess length or slack over nearby components to  
help keep them off the floor.  
Figure: 2  
Route cord out the rear of the dishwasher so that it does not  
touch dishwasher motor or lower part of dishwasher tub.  
A maximum of 2 power cord supply conductors (12 AWG  
largest size) plus 1 grounding conductor are permitted in the  
terminal box.  
Contact surface  
IMPORTANT: No additional connections other than dishwasher  
power connection are to be made inside the dishwasher terminal  
box.  
The stripped wire should always  
have a 2/3 to 3/4 wrap around  
the screw threads  
INSTALL DOOR HANDLE  
(ON SOME MODELS)  
Figure: 3  
25. Install door handle  
23. Secure cord or wire in strain relief  
Mounting stud  
Handle  
Setscrew  
(in bottom  
of handle)  
Hex key  
IMPORTANT: Do not scratch the front panel during this  
procedure. If door panel has a protective film, peel film back past  
the point of the handle studs before installing handle. Handle is  
easiest to install while unit is on its back.  
Tighten strain relief screws to secure cord.  
19  
GeneralDetails
NameKitchenAid w11323304 Dishwasher
MakeKitchenAid
LanguageEnglish
FiletypePDF (Download)
File size12.18 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
KitchenAid KDTE304RBS Third Level Jet Rack Dishwasher
KitchenAid KDTE304RBS Third Level Jet Rack Dishwasher
KitchenAid KDTF324PPA Dishwasher
KitchenAid KDTF324PPA Dishwasher
Kitchenaid MVWC565FW1 Dishwasher
Kitchenaid MVWC565FW1 Dishwasher
KitchenAid KDFE104KWH Two Rack Dishwasher
KitchenAid KDFE104KWH Two Rack Dishwasher
KitchenAid KDTE104KPS Dishwasher
KitchenAid KDTE104KPS Dishwasher
KitchenAid KDFE104KBL Front Dishwasher
KitchenAid KDFE104KBL Front Dishwasher
KitchenAid KDTF924PPS Flush Cabinet Dishwasher
KitchenAid KDTF924PPS Flush Cabinet Dishwasher
KitchenAid KDTE304RBS Level Jet Rack Dishwasher
KitchenAid KDTE304RBS Level Jet Rack Dishwasher
KitchenAid KDF Series Dishwasher
KitchenAid KDF Series Dishwasher
KitchenAid W11589937B Dishwasher
KitchenAid W11589937B Dishwasher

KitchenAid w11323304 Dishwasher