Home > LORD > lord D8 Dishwasher

lord D8 Dishwasher

Step 3. Tension adjustment of the door spring  
(valid only for D6 model)  
1. The door springs are set at the factory to the  
proper tension for the outer door. If aesthetic  
wooden panel are installed, you will have to  
adjust the door spring tension.  
Rotate the adjusting screw to drive the adjustor  
to strain or relax the steel cable.  
2. Door spring tension is correct when the door  
remains horizontal in the fully opened position,  
yet rises to a close with the slight lift of a ꢀnger.  
Step 4. Dishwasher installation steps  
Please refer to the speciꢀed installation steps in the installation drawings.  
1. Aꢂx the condensation strip under the work surface of cabinet. Please ensure the  
condensation strip is ꢃush with edge of work surface. (Step 2)  
2. Connect the inlet hose to the cold water supply.  
3. Connect the drain hose.  
4. Connect the power cord.  
5. Place the dishwasher into position. (Step 4)  
6. Level the dishwasher. The rear foot can be adjusted from the front of the  
dishwasher by turning the Philips screw in the middle of the base of dishwasher  
use an Philips screw. To adjust the front feet, use a ꢃat screw driver and turn the  
front feet until the dishwasher is level. (Step 5 to Step 6)  
7. Install the furniture door to the outer door of the dishwasher. (Step 7 to Step 10)  
8. Adjust the tension of the door springs by using an Allen key turning in a clockwise  
motion to tighten the left and right door springs. Failure to do this could cause  
damage to your dishwasher. (Step 11)  
21  
GeneralDetails
Namelord D8 Dishwasher
MakeLORD
LanguageEnglish
FiletypePDF (Download)
File size24.44 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
lord D5 Dishwasher
lord D5 Dishwasher
lord D1000 Dishwasher
lord D1000 Dishwasher
lord D3 Dishwasher
lord D3 Dishwasher

lord D8 Dishwasher