Home > Monsher > Monsher MD 4502 Dishwasher

Monsher MD 4502 Dishwasher

70  
English  
Step 3. Tension adjustment of the door spring  
1. The door springs are set at the  
factory to the proper tension for the  
outer door. If aesthetic wooden panel  
are installed, you will have to adjust  
the door spring tension. Rotate the  
adjusting screw to drive the adjustor to  
strain or relax the steel cable.  
2. Door spring tension is correct  
when the door remains horizontal in  
the fully opened position, yet rises to a  
close with the slight lift of a finger.  
Step 4. Dishwasher installation steps  
Please refer to the specified installation steps in the installation drawings.  
1. Affix the condensation strip under the work surface of cabinet. Please ensure  
the condensation strip is flush with edge of work surface.  
2. Connect the inlet hose to the cold water supply.  
3. Connect the drain hose.  
4. Connect the power cord.  
5. Place the dishwasher into position.  
6. Level the dishwasher. The rear food can be adjusted from the front of the  
dishwasher by turning the Philips screw in the middle of the base of dishwasher  
use an Philips screw. To adjust the front feet, use a flat screw driver and turn the  
front feet until the dishwasher is level.  
7. Install the furniture door to the outer door of the dishwasher.  
8. Adjust the tension of the door springs by using an Allen key turning in a  
clockwise motion to tighten the left and right door springs. Failure to do this could  
cause damage to your dishwasher.  
GeneralDetails
NameMonsher MD 4502 Dishwasher
MakeMonsher
LanguageEnglish
FiletypePDF (Download)
File size12 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
Monsher MD 6003 Dishwasher
Monsher MD 6003 Dishwasher
Monsher MD 6001 Dishwasher
Monsher MD 6001 Dishwasher

Monsher MD 4502 Dishwasher