Whirlpool WDFS3R4NWESG Sense Dishwasher
Daily Reference Guide
EN
CLEANING THE SPRAY ARMS
The lower spray arm may be removed
by pulling it upwards and rotating
it anti-clockwise. Mounting back
the spray arm is by pulling it down
and rotating it clockwise.
On occasions, food residue
may become encrusted onto
the spray arms and block the
holes used to spray the water. It
is therefore recommended that
you check the arms from time
to time and clean them with
a small non-metallic brush.
The top spray arm may be removed
by pressing it up and then rotating
it anti-clockwise. Mounting back
the spray arm is by pulling it upwards
and rotating it clockwise.
To remove the upper spray you
must remove it together with
the manifold.
TROUBLESHOOTING
In case your dishwasher doesn’t work properly, check if the problem can be solved by going through the following list.
For other errors or issues please contact authorized After-sales Service whose contact details can be found in the warranty booklet.
PROBLEMS POSSIBLE CAUSES
The salt
SOLUTIONS
Refill the reservoir with salt (for more information - see FILLING THE SALT RESERVOIR). Check the
water hardness setting if necessary (see SETTING THE WATER HARDNESS)
Salt reservoir is almost empty.
indicator is lit
The salt indicator
Salt reservoir is empty.
is blinking
Refill the reservoir with salt as soon as possible. Using the appliance without salt may cause
damage to its internal components.
The rinse aid
indicator is lit
or blinking
Rinse aid dispenser is empty. (After refill the rinse
aid indicator may remain lit for a short time).
Refill the dispenser with a rinse aid (for more information - see FILLING THE RINSE AID DISPENSER).
Descale indicator
is lit or blinking;
"dES" alarm is
displayed.
Descale the appliance immediately using the Self-Clean program and a commercially available
descaling product (see OPTIONS AND FUNCTIONS). Refill the reservoir with salt. Check the water
hardness setting. If the appliance is not descaled, it will stop functioning.
Limescale is accumulating on internal components
of the appliance
The dishwasher
won’t start or does
not respond to
commands.
The appliance has not been plugged in properly. Insert the plug into the socket.
For safety reasons, the dishwasher will not restart automatically when power returns.
Close the door and press START/Pause button.
Power outage.
The dishwasher door is not closed.
NaturalDry pin is not pulled in.
Vigorously push the door until you hear the “click”.
A cycle is interrupted by the door opening for
more than 4 seconds.
Close the door within 4 sec. and press START/Pause button.
Switch off the appliance by pressing the ON-OFF/Reset button, switch it back on after approxi-
mately one minute and restart the program. If the problem persists, unplug the appliance for 1
minute, then plug it back in.
The Control panel does not respond or F6 E1 is
displayed.
The dishwasher
won’t drain.
Display shows:
F7 E3 or F9 E1
Clean the filter and descale the appliance (see CLEANING THE FILTER ASSEMBLY and DESCALE
INSTRUCTION).
Filter is clogged with food residues or limescale
The drain hose is kinked.
Check the drain hose (see INSTALLATION INSTRUCTIONS).
Clean the sink drain pipe.
The sink drain pipe is blocked.
The dishwasher
makes excessive
noise.
Dishes are rattling against each other.
Position the crockery correctly (see LOADING THE RACKS).
The detergent has not been measured out correctly or it is not suitable for use in dishwashers
(see FILLING THE DETERGENT DISPENSER). Restart the current cycle by switching OFF the dish-
washer, then switch it on again, select a new program, close the door and press START/Pause.
Please do not add any detergent.
An excessive amount of foam is present.
Crockery has not been arranged properly.
Arrange the crockery correctly (see LOADING THE RACKS).
The filter is clogged with food residues or limescale. Clean the filter assembly (see CARE AND MAINTENANCE).
The dishes are not
clean.
Crockery has not been arranged properly.
Arrange the crockery correctly (see LOADING THE RACKS).
Spray arms cannot rotate freely, being hindered Arrange the crockery correctly (see LOADING THE RACKS). Check that the upper rack is in the
by the dishes.
correct position and adjust (lift up) if necessary
The wash cycle is too gentle.
Select an appropriate wash cycle (see PROGRAMS TABLE).
The detergent has not been measured out correctly or it is not suitable for use in dishwashers (see
FILLING THE DETERGENT DISPENSER).
An excessive amount of foam is present.
The cap on the rinse aid compartment has not
been closed correctly.
Make sure the cap of the rinse aid dispenser is closed.
The filter is clogged with food residues or limescale. Clean the filter and descale the appliance (see CLEANING THE FILTER ASSEMBLY).
The salt reservoir is empty. Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
11
| General | Details |
|---|---|
| Name | Whirlpool WDFS3R4NWESG Sense Dishwasher |
| Make | Whirlpool |
| Language | English |
| Filetype | PDF (Download) |
| File size | 6.06 MB |
(1 votes, average: 5.00 out of 5)
Loading...
Whirlpool 2B19 Dishwasher
Whirlpool WFO3O33PLAUS Standard Dishwasher
Whirlpool W11323304G Dishwasher
Whirlpool WH7IPC15BM60 Dishwasher
Whirlpool FINPUTSAD Dishwasher
Whirlpool W7U HS31 X Dishwasher
Whirlpool Thron Dishwasher
Whirlpool WDF332PAMS 24 Front Tall Tub Dishwasher
Whirlpool WRF540CWHZ Dishwasher
Whirlpool WDF130PAHB Dishwasher
BOSCH SBH4ECX21E Dishwasher
FRIGIDAIRE GDPP4517A Gallery Series Dishwasher
BOSCH SMI4ECS22E Dishwasher
Amana ADB1400PY Undercounter Dishwasher
smeg LSPU8653X 24″ Fingerprint Resistant Dishwasher
WISBERG WBDW44DB Dishwasher
KitchenAid W11373417 Dishwasher
Electrolux KEQC7210L Air Dry Dishwasher
LG LRFLC2706S Dishwasher
FISHER AND PAYKEL DD24SCTX9 N Dish Drawer Dishwasher