Home > BLACK PLUS DECKER > BLACK Plus DECKER BDW200M Dishwasher
BLACK Plus DECKER BDW200M Dishwasher
ENGLISH
INSTALLATION INSTRUCTIONS
• Turn on the sink hot water faucet and verify the water temperature. Incoming
water temperature must be between 120°F and 150°F. A minimum of 120°F
temperature is required for best wash performance. See Preparing the hot
water line.
• Add a half gallon (2 l) of water to the bottom of the dishwasher to lubricate the
pump seal.
• Turn on the water supply. Check for leaks. Tighten connections if needed.
• Remove any protective film (if present) from the control panel and door.
Step 15: Wet testing the dishwasher
1. Turn on the power supply (or plug the power cord into the outlet, if equipped).
2. Turn on your dishwasher (refer to the User Guide for instructions).
3. Close the door, select the Rinse only cycle, and press START/Cancel.
4. Make sure that water enters the dishwasher. If water does not enter the
dishwasher, check to be sure that water and power are turned on.
5. Check for leaks under the dishwasher. If a leak is found, turn the power supply
off, then tighten connections. Restore power after the leak is corrected.
6. Check for leaks around the door. A leak around the door could be caused by
door rubbing or hitting against adjacent cabinetry. Reposition the dishwasher
if necessary. See “Step 9: Position the dishwasher under the countertop.
7. When the dishwasher is draining, check the drain lines. If leaks are found, turn
power off at the breaker and correct plumbing as necessary.
8. Restore the power after corrections are made. See “Step 12: Connecting the
water supply line.
9. Open the dishwasher door and make sure that most of the water has drained.
If not, check that the disposer plug has been removed and/or the air gap is not
plugged. See “Step 13: Connecting the drain hose. Also check the drain line for
kinking.
10. Run the dishwasher through another fill and drain cycle. Check for leaks and
correct if required.
Step 16: Replacing the toekick
• Place the toekick against the legs of the dishwasher. The slots should align with
the toekick bracket screw holes. Allow the toekick to touch the floor. Install the
toekick screws.
Note: Make sure that you install the toekick in the correct direction. The toekick
should be aligned correctly with the junction box.
You’ll need
Phillips screwdriver
Page 21
| General | Details |
|---|---|
| Name | BLACK Plus DECKER BDW200M Dishwasher |
| Make | BLACK PLUS DECKER |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.78 MB |
(1 votes, average: 5.00 out of 5)
Loading...
BLACK plus DECKER BDW300MHS Dishwasher
BLACK PLUS DECKER BDW200MW Dishwasher
FISHER PAYKEL DD60SHTI9 Integrated Single Dishwasher
SIEMENS SN63EX01CE Fully Integrated Dishwasher
FISHER AND PAYKEL DD24SA9 Dishwasher
BOSCH SMS6ZDW11E Dishwasher
FISHER PAYKEL DD60SHTI9 Dishwasher
Electrolux ESZ89400UX 800 SprayZone Dishwasher
FISHER PAYKEL DD60DCHX9 Dishwasher
FISHER AND PAYKEL DD24DT4NX9 Dishwasher
BOSCH SMS2ITW00I Free Standing Dishwasher
CMA DISHMACHINES UC65e M3 Undercounter Dishwasher