Home > Town Appliance > Town Appliance W11711835A Dishwasher

Town Appliance W11711835A Dishwasher

NOTE: If using a flexible braided hose, replace inlet hose after  
5 years to reduce the risk of hose failure. Record hose installation  
or replacement dates on the hose for future reference.  
Shelter dishwasher and water lines leading to dishwasher  
against freezing. Damage from freezing is not covered by  
the warranty.  
NOTE: If dishwasher will be left unused for a period of time  
or in a location where it may be subject to freezing, have it  
winterized by authorized service personnel.  
For Direct Wire  
For Power Cord  
If installed in new construction, flush the water supply line of  
debris before connecting it to the fill valve. If it is not  
flushed, debris from the water supply could plug the fill  
valve screen.  
A square opening for proper operation and appearance.  
The cabinet front to be perpendicular to floor.  
A level floor.  
Helpful Hint: If floor at front of opening is not level with floor at  
rear of opening, shims may be used to level dishwasher.  
Cabinet Grommet  
Power Cord Kit  
NOTE: To avoid shifting during dishwasher operation, shims must  
be securely attached to the floor.  
For 11/2" (38 mm) hole in  
cabinet  
NOTE: Required for metal  
Kit typically includes power  
cord, metallic strain relief,  
grommet, and twist-on wire  
connectors (Straight: Whirlpool  
Part Number 4317824, 90°:  
Whirlpool Part Number  
W10278923RP). For proper  
installation, refer to the  
installation instructions  
The location where the dishwasher will be installed must  
provide clearance between motor and flooring. Motor should  
not touch the floor.  
If connecting to a power outlet, the power-supply receptacle for  
the appliance shall be installed in a cabinet or on a wall  
adjacent to the under counter space in which the appliance is  
to be installed.  
cabinets  
Do not install dishwasher over carpeted flooring.  
provided with the kit.  
NOTE: Not intended for factory  
power cord connected units.  
Cabinet Opening Dimensions  
Clearances  
Power cord to direct wire conversion kit (for models with  
power cords attached from the factory only).  
Check that all surfaces have no protrusions that would prohibit  
dishwasher installation.  
Use W11712562 connect a factory cord connected appliance to a  
hardwire installation.  
NOTE: Be sure to purchase only Whirlpool factory-certified parts  
and accessories for your appliance. Your installation may require  
additional parts. To order, refer to the contact information  
referenced in your Quick Start Guide.  
34"  
1
10 /2  
"
(864 mm)  
A
4"  
(267 mm)  
(102 mm)  
3
6 /4  
"
Location Requirements  
Dishwasher must be fully enclosed (top, sides, back, and floor)  
upon installation. A side panel kit is available from your dealer for  
installing your dishwasher at the end of your cabinetry.  
(172 mm)  
3"  
(76 mm)  
1
6 /4  
"
1
2 /4  
(159 mm)  
"
(64 mm)  
24"  
(620 mm)  
3
1 /4  
"
(44 mm)  
2"  
(51 mm)  
An optional moisture barrier accessory is also available for  
installing underneath a wooden countertop.  
24"  
(620 mm)  
B
Check location where dishwasher will be installed. The location  
must provide:  
Convenient access for loading and unloading dishes. Corner  
locations require a 2" (51 mm) minimum clearance between  
the side of the dishwasher door and the wall or cabinet.  
A. Measured from the lowest point on the underside of the countertop.  
May be reduced to 331/2" (851 mm) by removing the wheels and  
perforated area of insulation (blanket) on dishwasher.  
B. Minimum, measured from narrowest point of opening.  
Easy access to water, electricity, and drain:  
NOTE: Shaded areas of cabinet walls show where utility  
Grounded electrical supply is required.  
This dishwasher has a water-heating feature and also  
requires a connection to a hot water supply line.  
connections may be installed.  
Make sure pipes, wires, and drain hose are within the  
shaded area shown in the “Cabinet Opening Dimensions”  
section.  
Do not run drain lines, water lines, or electrical wiring where  
they can interfere with or contact dishwasher motor or legs.  
7
   
GeneralDetails
NameTown Appliance W11711835A Dishwasher
MakeTown Appliance
LanguageEnglish
FiletypePDF (Download)
File size14.45 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

Town Appliance W11711835A Dishwasher