MONOGRAM CDT845P4NW2 Interior Dishwasher
Dishwasher Installation
DISHWASHER WET TEST
ꢀ Turn on power supply or plug power cord into outlet,
if equipped.
POSITION SOUND
INSULATION PIECE
(on some models)
STEP 18
STEP 19
ꢀ Select a cycle to run and push the Start pad.
ꢀ Locate the sound insulation package inside the
dishwasher.
ꢀ Ensure the door is latched. Dishwasher should start.
ꢀ Stand the parts upright as shown.
ꢀ Check to be sure that water enters the dishwasher.
If water does not enter the dishwasher, check to be
sure that water and power are turned on.
Dishwasher
Door
ꢀ Check for leaks under the dishwasher. If a leak
is found, turn off power at the breaker, and then
tighten water connections. Restore power after leak
is corrected.
NOTE: A small amount of water may splash out of
the fill funnel, on the right side of the tub, during the
first use after installation. Splash-out is most likely to
occur if there is air in the water supply line from new
construction or if the valve has been closed for an
extended time.
Toekick
Insulation Block
(On some models.)
ꢀ Locate the control box.
Control Box
ꢀ Check for leaks around the door. A leak around
the door could be caused by door rubbing or
hitting against adjacent cabinets. Reposition the
dishwasher if necessary. See Step 11.
B
ꢀ Press and hold the Start pad for 3 seconds to
cancel the cycle. The unit will begin to drain. Check
drain lines. If leaks are found, turn off power at the
breaker and correct plumbing as necessary. Restore
power after corrections are made. See Steps 4, 6, 7,
8 and 15.
ꢀ Push insulation block portion under the dishwasher
until it is beneath the control box.
ꢀ Open dishwasher door and make sure all of the
water has drained. If not, check that disposer plug
has been removed and/or air gap is not plugged.
Also check drain hose to be sure it is not kinked
underneath or behind dishwasher. See Step 15.
Figure AH
ꢀ Press Start pad once again and run dishwasher
through another cycle. Check for leaks and correct if
required.
ꢀ Push the panel portion up to the front of the block.
ꢀ Repeat these steps as necessary.
(on some models)
Push the sides of the insulation behind the toekick
attachment screw holes
ꢀ Tuck the sides of the front panel behind the toekick
attachment screw holes.
22
| General | Details |
|---|---|
| Name | MONOGRAM CDT845P4NW2 Interior Dishwasher |
| Make | MONOGRAM |
| Language | English |
| Filetype | PDF (Download) |
| File size | 33.22 MB |
(1 votes, average: 5.00 out of 5)
Loading...
MONOGRAM UDT165SIVII 18 Inch Dishwasher
MONOGRAM ZDT925SINII Dishwasher
MONOGRAM ZDT985SINII Dishwasher
MONOGRAM ZDT985SINII Fully Integrated Dishwasher
FISHER PAYKEL DD24DT2NX9 Dishwasher
BOSCH SMI6ZCS49E-39 Dishwasher
FISHER PAYKEL DD60SI9 Sanitise Integrated Single DishDrawer Dishwasher
TEKNIX TBD606 Dishwasher
NOBLE I-E SERIES-I HH Low Temperature Tall Door Type Dishwasher
smeg LVS344PM 60 cm Free Standing Dishwasher
Midea MDF18A1AWW Dishwasher
Westinghouse WSF6608KXB Sensor Wash Dishwasher
Whirlpool WFE2B19X Dishwasher
FISHER AND PAYKEL HDW13V1W1 Dishwasher