MONOGRAM CDT845P4NW2 Interior Dishwasher
Dishwasher Installation
POSITION DISHWASHER,
POSITION DISHWASHER,
STEP 13
STEP 13
SECURE TO
COUNTERTOP OR
CABINET
SECURE TO
COUNTERTOP OR
CABINET (CONT.)
ꢀ Re-check that the dishwasher is square and level at
both the top and bottom of the cabinet opening, with no
twisting or distortion of the tub or door after mounting to
the cabinets/countertop. Adjust if necessary.
In this step you will need the 2 Phillips special head
screws from the screws set aside earlier.
The dishwasher must be secured to the countertop
or the cabinet sides. When the underside of the
countertop is wood, use Method 1. Use Method 2
when the underside of the countertop is made of a
material, such as granite, that will not accept wood
screws.
ꢀ Confirm all leveling legs are in contact with the floor
to prevent the dishwasher from rocking and ensure
proper door and latch operation.
IMPORTANT – Prevent door panel and control
panel damage. Dishwasher must be positioned so
the front panel and control panel do not contact the
adjacent cabinets or countertop. Mounting screws
must be driven straight and flush. Protruding screw
heads could scratch the door panel or control panel
and interfere with door operation.
CONNECT WATER
STEP 14
SUPPLY
Connect water supply line to 90° elbow.
If using a flexible braided hose connection:
ꢀ Attach nut to 90° elbow using an adjustable wrench.
If using a copper tubing connection:
Method 1
Secure dishwasher to underside of wood countertop.
ꢀ Slide compression nut, then ferrule over end of water
line.
ꢀ Recheck alignment of the dishwasher in the cabinet.
Refer to Steps 11 and 12. Door panel and/or control
panel must not hit cabinets or countertop.
ꢀ Insert water line into 90° elbow.
ꢀ Slide ferrule against elbow and secure with
compression nut.
ꢀ Fasten the dishwasher to the underside of the
countertop with the 2 Phillips special head screws.
Refer to figure. Make certain screws are driven
straight and flush to prevent panel damage.
IMPORTANT – Check to be sure that door spring and/
or door spring cable do not rub or contact the fill hose
or water supply line. Test by opening and closing the
door. Re-route the water supply lines if a rubbing noise
or interference occurs.
Brackets Wood Countertop
Hot Water
Supply Line
Compression
Nut
90° Elbow
Method 2
Ferrule
Secure dishwasher to cabinet sides.
ꢀ Recheck alignment of the dishwasher in the cabinet.
Refer to Steps 11 and 12. Door panel and/or control
panel must not hit cabinets or countertop.
Figure Y
Bottom Left Side
ꢀ Remove plug buttons. Do not discard.
ꢀ Fasten the dishwasher to the adjacent cabinets with
the 2 Phillips special head screws provided. Refer
to Figure X. Make certain screws are driven straight
and flush to prevent panel damage. Do not screw
into the cabinet face frame.
CONNECT DRAIN LINE
STEP 15
ꢀ The hose should have already been detached from
the tub at locations indicated.
The molded end of the drain hose will fit 5/8” through
1” diameter inlet ports on the air gap, waste tee or
disposer.
ꢀ Install plug buttons to the side of the tub in the holes
provided.
Solid Surface Countertop
Screw
Screw
Plug buttons
Side Brackets
Figure X
19
| General | Details |
|---|---|
| Name | MONOGRAM CDT845P4NW2 Interior Dishwasher |
| Make | MONOGRAM |
| Language | English |
| Filetype | PDF (Download) |
| File size | 33.22 MB |
(1 votes, average: 5.00 out of 5)
Loading...
MONOGRAM UDT165SIVII 18 Inch Dishwasher
MONOGRAM ZDT925SINII Dishwasher
MONOGRAM ZDT985SINII Dishwasher
MONOGRAM ZDT985SINII Fully Integrated Dishwasher
VALBERG 14S44 C XAD929C,14S44 C DXAD929C Dishwasher
BOSCH SPH4HKX10E Dishwasher
ZLINE Kitchen DWMT Monument Dishwasher
smeg STX23CLLO Classica Undercounter dishwasher
BOSCH SMS2HTI02E Dishwasher
FISHER AND PAYKEL DD24SCTW9 N Contemporary Tall Dishwasher
IKEA 304.754.26 LAGAN Integrated Dishwasher
BOSCH SMS4HKW00G Dishwasher
Thermador Dishwasher : for DWHD650W and More
FISHER AND PAYKEL DD60SDFTB9 Single DishDrawer Dishwasher