MONOGRAM CDT845P4NW2 Interior Dishwasher
Dishwasher Installation
STEP 1
INSTALL HANDLE
(on some models)
STEP 2
CHECK DOOR BALANCE
CAUTION
ꢀ Remove the packaged handle from the lower rack
by pulling its shipping clips out and up.
Opening the door will cause the dishwasher
to tip forward when it is not fully installed.
When opening the door prior to the
dishwasher being fully installed, hold the top of the
dishwasher securely with one hand and hold the
door with the other hand. Gloves should be worn.
NOTE: If installing
a Custom Door
Panel (available
on some models),
please follow the
Door
closes
within
20°
Door stays in
position from
instructions found
in the Custom
20° to 70°
Door Panel kit
WD35X25996.
Door falls fully
open beyond 70°
ꢀ With dishwasher
on the wood
base and holding
the top of the
Side View
dishwasher firmly, check the door balance by opening
and closing the door.
ꢀ Door is properly balanced if, when opened, it self
closes within 20° from vertical, stays in position from
20° to 70° and falls fully open beyond 70°.
ꢀ Using the provided 1/8” Allen wrench, loosen the set
screws to remove the shipping clips and discard them.
ꢀ If necessary increase or decrease tension as shown.
Some models will have 2 springs on one side and
1 spring on the other side. Latch door and adjust
springs to correct balance.
NOTE: Models with tubular base rails are not
adjustable.
Remove and
discard the
shipping clips
Spring
hooked
to hole
inside rail
Side View
ꢀ Place the handle on the dishwasher door mounting
fasteners, with the set screws on the bottom side,
then tighten the set screws with the Allen wrench.
Increase
Tension
Decrease
Tension
Custom
door
NOTE: The number of
springs, on each side,
will vary by model.
panel
Make sure pully
cables are within
pulley shoulders
Front View
Figure H
Tip: Make sure door opens and closes smoothly.
Check door opening and closing. If door does not open
easily or falls too quickly, check spring cable routing.
The cable is held in place by “shoulders” on the pulley.
Check to be sure cable has not slipped over the pulley
shoulders and is routed as shown.
Fasten both sides
using the 1/8”
Allen wrench
13
| General | Details |
|---|---|
| Name | MONOGRAM CDT845P4NW2 Interior Dishwasher |
| Make | MONOGRAM |
| Language | English |
| Filetype | PDF (Download) |
| File size | 33.22 MB |
(1 votes, average: 5.00 out of 5)
Loading...
MONOGRAM UDT165SIVII 18 Inch Dishwasher
MONOGRAM ZDT925SINII Dishwasher
MONOGRAM ZDT985SINII Dishwasher
MONOGRAM ZDT985SINII Fully Integrated Dishwasher
SHARP SDW6888JS Slide in Smart Dishwasher
JOCEL JLLI023124 Dishwasher
SIEMENS SN13EW78CS Dishwasher
smeg LSPU8643WH Dishwasher
AVG DW-WQP12 Dishwasher
FISHER and PAYKEL DW24UT2I2 Series 7 Integrated Dishwasher
IKEA 704.756.17 RENODLAD Integrated Dishwasher
Midea WQP4-2605 Tabletop Dishwasher
AEG FSK76748P Dishwasher
SIEMENS SN63HX60CE Dishwasher