CHAMPION 2000 Series Door type Dishwasher
Installation
Vent Fan Control
1. A vent fan control signal is provided on a terminal block
located inside the top-mounted control cabinet. The
terminal locations are clearly marked.
2. The 120VAC signal is designed only to operate an external
vent
SIGNAL ONLY
VENT FAN
120V
COMMON
fan contactor (supplied by others) and is limited to 1 AMP
maximum load and is available when the dishwasher
power switch is turned ON.
The Vent Fan Control Signal is limited to
120VAC 1 Amp maximum load.
CAUTION:
Do not connect a vent fan motor to the signal connection
terminals.
Chemical Dispenser Provisions
Provisions for chemical suppliers to connect their
chemical dispensing systems are provided on the
dishwasher and include:
Rinse-aid
1. A 1/4" NPT plastic fitting as a rinse-aid injection
point. The fitting is installed in the upper final
rinse piping located at the top-rear of the
dishwasher (see illustration at left).
2. Two 7/8" holes are provided on the right-side
rear of the wash tank as detergent injection
points.
Detergent
3. Detergent and rinse-aid control signals are
available inside the top-mounted control cabinet.
The signals are 120VAC, Max. 1 Amp load.
Connection points are located on a
labeled terminal block (see below).
4. Do not remove the jumper between the common
terminals.
SIGNAL ONLY
Detergent and Rinse-aid Injection Points
VENT FAN
120V
COMMON
RINSE AID
120V
NOTE:
Consult a qualified chemical supplier for chemical
supplies and chemical dispensing equipment.
COMMON
A commercial grade non-chlorinated detergent
is recommended for use with this machine.
DETERGENT
120V
DO NOT REMOVE THE JUMPER
BETWEEN THE COMMON TERMINALS
7
| General | Details |
|---|---|
| Name | CHAMPION 2000 Series Door type Dishwasher |
| Make | Champion |
| Language | English |
| Filetype | PDF (Download) |
| File size | 5.84 MB |



























































