Home > ZLINE Kitchen > ZLINE Kitchen DW7713 Classic Dishwasher

ZLINE Kitchen DW7713 Classic Dishwasher

INSTALLATION  
Step 6: Preparing the Dishwasher  
Ensure that the circuit breaker and water supply valve are turned off before  
proceeding with the following steps.  
1. Before you move or lay down the dishwasher for installation, adjust the height of the legs  
so they are as short as possible. This prevents the legs from breaking. Level the dishwasher  
by adjusting the legs after you have the dishwasher in place.  
2. Make sure there are no kinks and that the hose is not bent at any extreme angles that might  
constrict the flow of water.  
3. Remove the junction box cover located at the bottom front right of the dishwasher using  
a screwdriver, and then install the strain relief (see Figure 4-C). Make sure to keep the  
junction box cover; it is used in "Step 11: Electrical Wiring Connections" on page 21.  
4. If the countertop is made of wood or a material not damaged by drilling, attach the two  
installation brackets supplied with the dishwasher using the supplied screws (see Figure  
4-A). They will be used in "" on page 16.  
5. Fasten a 90° Elbow joint onto the water inlet valve located at the bottom front left of the  
dishwasher (see Figure 5); wrap Teflon tape or sealing compound around the thread of  
the 90° Elbow to ensure a snug seal.  
Do not overtighten the 90° elbow. Doing so may damage the water inlet  
valve and cause a water leak.  
WARNING  
Figure 5  
Figure 4  
14  
GeneralDetails
NameZLINE Kitchen DW7713 Classic Dishwasher
MakeZLINE Kitchen
LanguageEnglish
FiletypePDF (Download)
File size1.07 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
ZLINE Kitchen DWV Tallac Dishwasher
ZLINE Kitchen DWV Tallac Dishwasher
ZLINE Kitchen DWMT Monument Dishwasher
ZLINE Kitchen DWMT Monument Dishwasher

ZLINE Kitchen DW7713 Classic Dishwasher