Indesit 869991713220 Dishwasher
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
FILLING THE RINSE AID DISPENSER
After installation, remove the stoppers from the racks and the retaining Rinse aid makes dish DRYING easier. The rinse aid dispenser A should
elastic elements from the upper rack.
be filled when when the dark optical indicator on the dispenser door C
becomes transparent.
C
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes
and on the machine’s functional components.
•
•
It is mandatory that THE SALT RESERVOIR NEVER BE EMPTY.
It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher (see
PRODUCT DESCRIPTION) and must be filled when the SALT REFILL indi-
B
A
cator light
in the control panel is lit.
1. Open the dispenser B by pressing and pulling up the tab on the lid.
2. Pour in the rinse aid (max.110 ml), making sure it does not overflow
from the dispenser. If this happens, clean the spill immediately with
a dry cloth.
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. Only the first time you do this: fill the salt
reservoir with water.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
3. Position the funnel (see figure) and fill the salt
reservoir right up to its edge (approximately 1
kg); it is not unusual for a little water to leak out.
4. Remove the funnel and wipe any salt residue
away from the opening.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satisfied with the drying results, you can
adjust the quantity of rinse aid used.
• Switch the dishwasher on using the ON/OFF button.
• Switch it off using the ON/OFF button.
Make sure the cap is screwed on tightly, so that no detergent can
get into the container during the wash program (this could damage
the water softener beyond repair).
Whenever you need to add salt, it is mandatory to complete
the procedure before the beginning of the washing cycle to avoid
corrosion.
• Press button START/Pause three times.
• Switch it on using the ON/OFF button.
• The START/Pause LED light will flash as many times as the level that
was set.
• Set the level of rinse aid quantity to be supplied using the PROGRAM
SELECTION knob (see PROGRAMS TABLE).
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in your
house. This information can be obtained from your local water supplier.
The factory sets the default value for the water hardness
• Switch on the appliance by pressing the ON/OFF button.
• Switch off the appliance by pressing the ON/OFF button.
• Hold down button START/Pause for 5 seconds.
• Switch it off using the ON/OFF button
Setting is complete!
If the rinse aid level is set to 1 (ECO), no rinse aid will be supplied.
A maximum of 5 levels can be set according to the dishwasher model.
The factory setting is specific to the model, please follow instruction
above to check this for your machine.
• If you see bluish streaks on the dishes, set a low number (2-3).
• If there are drops of water or limescale marks on the dishes,
set a mid-range number (4-5).
• Switch on the appliance by pressing the ON/OFF button.
• The ON/OFF LED light will flash as many times as the level that was
set.
• Set the desired water hardness level using the PROGRAM SELEC-
TION knob (see WATER HARDNESS TABLE).
FILLING THE DETERGENT DISPENSER
Water Hardness Table
To open the detergent dispenser use the opening device D.
Introduce the detergent into the dry dispenser E only.
Place the amount of detergent for pre-washing directly inside
the tub.
°dH
German
degrees
°fH
French
degrees
°Clark
English
degrees
Level
1. Whenmeasuringoutthedetergent
refer to the mentioned earlier
information to add the proper
quantity. Inside the dispenser
1
2
Soft
0 - 6
0 - 10
0 - 7
Medium
Average
Hard
7 - 11
11 - 20
8 - 14
3
4
5
12 - 16
17 - 34
35 - 50
21 - 29
30 - 60
61 - 90
15 - 20
21 - 42
43 - 62
E
E there are indications to help
the detergent dosing.
D
2. Remove
detergent
residues
Very hard
from the edges of the dispenser
and close the cover until it clicks.
3. Close the lid of the detergent
dispenser by pulling it up until
the closing device is secured
in place.
• Switch off the appliance by pressing the ON/OFF button.
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specifically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches off.
The detergent dispenser automatically opens up at the right time
according to the program.
If the salt container is not filled, the water softener and the heating
element may be damaged as a result of limescale accumulation.
Usage of detergent not designed for dishwashers may cause
malfunction or damage to the appliance.
Using of Salt is recommended with any type of dishwasher detergent.
2
| General | Details |
|---|---|
| Name | Indesit 869991713220 Dishwasher |
| Make | INDESIT |
| Language | English |
| Filetype | PDF (Download) |
| File size | 6.26 MB |
(1 votes, average: 5.00 out of 5)
Loading...
INDESIT D2I HL326 Full Size Dishwasher
Indesit D2F HD624 A Separate Dishwasher
INDESIT I0F D641A X Free Standing Dishwasher
Indesit I0F D641A Dishwasher
INDESIT DFE 1B19 14 Dishwasher
INDeSIT D2F Dishwasher
INDeSIT D2I HD524 A Dishwasher
INDESIT W11667630 B Dishwasher
InDeSIT IN2FE10CS90S Dishwasher
inDeSIT DSIO3M24CS Dishwasher
FISHER PAYKEL DD24DHTI9 N Integrated Double Dishwasher
Electrolux EEC67310L Dishwasher
FISHER AND PAYKEL DD60SDFHTX9 Tall Single DishDrawer Dishwasher
CMA DISHMACHINES 180UC-3 Under Counter Dishwasher
STRLING STR-DWSS14 Dishwasher
Miele PFD 103 SCi XXL XXL Dishwasher
kogan KAGDWS15CTC Dishwasher
IKEA 304.754.26 LAGAN Integrated Dishwasher
FISHER PAYKEL DW24UT4I2 Dishwasher
MONOGRAM ZDT925SINII Dishwasher