SHARP SDW6506JS 24 Front Control Dishwasher
INSTALLATION INSTRUCTIONS
STEP 9: SLIDE DISHWASHER PARTIALLY
INTO CABINET
STEP 10: LEVEL DISHWASHER
IMPORTANT: The dishwasher must be level for proper dish rack
operation and wash performance.
WARNING
TIP OVER HAZARD
1 Level the dishwasher so its front panel is aligned with the adjacent
cabinet doors.
• Do not use dishwasher until completely installed.
• Do not push down on open door.
• Doing so can result in serious injury or cuts.
NOTE: With some installations, it may be easier to adjust the
front leg using a flat blade screwdriver.
• To lower - Turn the leveling leg counterclockwise.
• To raise - Turn the leveling leg clockwise.
1 Position power supply.
• If dishwasher has a power supply cord, insert power supply
cord into the hole cut into the cabinet.
• If using a direct-wire connection, check that the wiring is on
the front-right side of opening.
2 Make sure the drain hose is not kinked under the dishwasher
and there is no interference with the water line and wiring or
any other component.
Raise one side of
To raise
the dishwasher
To lower
3 Slowly move the dishwasher into the opening a few inches at
a time. As you proceed, pull the drain hose, water supply hose
and cord through the opening under the sink or cabinet. Stop
pushing when the dishwasher is a few inches in front of the
adjacent cabinetry.
2 Check that the leveling legs are firmly against the floor.
NOTE: Do not push against the front of the panel or on the
console, as this will cause denting.
3 Close and latch the door then place level against the front panel.
Check that dishwasher is plumb. If needed, adjust leveling leg or
add shims until dishwasher is plumb.
NOTE: Shims must be securely attached to floor to prevent their
movement when the dishwasher is operated.
4 Repeat for other side of dishwasher.
5 Place level on door and rack track inside the tub as shown. Check
that dishwasher is level from side to side, and from back to front.
If the dishwasher is not level, adjust front legs up or down until
dishwasher is level.
Reposition dishwasher by
grasping both sides with
hands.
Do not push against front door
panel with knee. Damage to
the door panel will occur.
4 Push dishwasher completely into the opening so that the front
corners of the dishwasher door are flush with the cabinet doors.
NOTE: It is all right if the dishwasher fits tightly into cabinet
opening. Do not remove the insulation blanket, as it reduces the
sound level.
Level front
to back
Level side
to side
NOTE: Pull lower rack out about halfway. If the rack rolls forward
or back into the dishwasher, the dishwasher must be leveled again.
13
| General | Details |
|---|---|
| Name | SHARP SDW6506JS 24 Front Control Dishwasher |
| Make | Sharp |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1.37 MB |
(1 votes, average: 5.00 out of 5)
Loading...
SHARP SDW6506JS 24 Front Dishwasher
SHARP SDW6888JS Smart Dishwasher
SHARP QW-NA1BF47EI-EU Series Dishwasher
SHARP QW-NA24S42DI-EE Dishwasher
SHARP SDW6767HS Dishwasher
SHARP SDW6767HS Slide In Smart Dishwasher
SHARP SDW6767HS Smart Dishwasher
SHARP QW-NA26F39DI-EN Dishwasher
SHARP QW-NS1CF49EI-ES Dishwasher
SHARP SDW6757ES Dishwasher
BOSCH SMV8ZCX07E Total Dishwasher
Whirlpool WDF110PAB 24 Inches Dishwasher
FISHER PAYKEL DW24U2I1 Drop Down Dishwasher
Bauknecht Dishwasher
BLACK plus DECKER BDW300MHS Dishwasher
Miele G 5000 SC Active Dishwasher
FISHER and PAYKEL DW60UC2X2 Contemporary Built under Dishwasher
SHARP SDW6757ES Dishwasher
FISHER PAYKEL DD24SCTB9_N Tall Dishwasher
BOSCH SMI6ZDS16E Dishwasher