Home > CMA Dishmachines > CMA DISHMACHINES CMA-180UC Under Counter Dishwasher
CMA DISHMACHINES CMA-180UC Under Counter Dishwasher
Getting Started
2.2.7. Booster Heater Setup (After Jan 2020)
Activating/Adjusting the Booster Heater
1. Booster heater must be filled with water prior to connecting the blue wire
from high limit switch. The high limit switch can be found by removing the
front panel and locating the red button on the front of the heater tank.
2. Once the booster has been connected, the thermostat should be adjusted to
maintain 180°F during the final rinse cycle. The thermostat is located on the
front of the booster tank and is accessible by removing the front panel on the
machine.
2.2.7. Booster Heater Setup (Prior to Jan 2020)
The booster tank must be filled with water before the heating element is energized.
For this reason the “High Limit Switch” has intentionally been disconnected at the
factory and will require re-connection before the heating element will turn on.
Follow the procedure below to complete the initial installation:
1. Close the door on the machine.
2. Turn the Power switch to the "ON" position.
3. On initial setup push Booster Fill button to fill the booster heater.
4. Turn Power switch OFF and On.
The machine will be automatically filled to the correct level.
5. Turn the Power switch to the "OFF" position.
6. Connect blue wire with disconnect, identified by red tag, to the High Limit
Switch which is located below the thermostat behind the front kick panel.
2.2.8. Installers Checklist
Dishmachine checked for concealed damage
Hot water supply is 120° F (49 C) — minimum
Incoming water supply line is ½” — minimum
Supply circuit breaker for machine is properly sized
Service voltage and phase type are correct to machine data plate
If drain pump is used, stand pipe drain should not exceed 22” maximum height
from the floor
Drain hose is installed with air gap (discharge 1” above drain)
Optional detergent and rinse dispenser (if present) is properly installed
Dishmachine is properly grounded
Dishmachine is properly leveled
Machine circuit breaker is labeled “DISHWASHER”
Machine has been “hard-wired” with correctly sized wire
Booster tank has been filled with water (before High Limit Switch is reset)
High Limit Switch for heater has been reset (after Booster Tank has been filled)
MODEL CMA-180UC INSTALLATION & OPERATION MANUAL Rev. 1.20
Page
12
| General | Details |
|---|---|
| Name | CMA DISHMACHINES CMA-180UC Under Counter Dishwasher |
| Make | CMA Dishmachines |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1.46 MB |
(1 votes, average: 5.00 out of 5)
Loading...
CMA DISHMACHINES EST-44 Conveyor Dishwasher
CMA DISHMACHINES EST-AH Door Type Rack Low Dishwasher
CMA DISHMACHINES UC65e M3 Dishwasher
CMA DISHMACHINES CMA-180VL Dishwasher
CMA DISHMACHINES UC50e Dishwasher
CMA DISHMACHINES CMA-180 Dishwasher
CMA DISHMACHINES CMA-180UC Dishwasher
CMA DISHMACHINES H-1X Undercounter Dishwasher
CMA DISHMACHINES 180UC-3 Under Counter Dishwasher
CMA DISHMACHINES AH Straight Thru Design Dishwasher
BOSCH SMV4HAX19E Dishwasher
BOSCH SHV88C73N Custom Panel Dishwasher
FISHER PAYKEL DD60D4ZB9 Dishwasher
FISHER and PAYKEL DD60D4ZB9 Dishwasher
SIEMENS SN13ES79CS Undercounter Dishwasher
AEG FSS64907Z 60 Cm Dishwasher
AEG FSE84727P Dishwasher
FISHER PAYKEL DD60DAW9 Dishwasher
FISHER and PAYKEL DD24DTX6HI1 Tall Dishwasher
INDESIT DFE 1B19 UK Dishwasher