Home > INDESIT > indesit DFG 15B1 Built Dishwasher

indesit DFG 15B1 Built Dishwasher

Start-up and use  
Measuring out the detergent  
Starting the dishwasher  
EN  
A good wash result also depends on the correct  
amount of detergent being used. Exceeding the stated  
amount does not result in a more effective wash and  
increases environmental pollution.  
1. Turn the water tap on.  
2. Switch on the appliance by pressing the ON/OFF button.  
3. Open the door and pour in a suitable amount of detergent  
(see Measuring out the detergent).  
4. Load the racks (see Loading the racks) and shut the door.  
5. Select the wash cycle by turning the SELECT WASH CYCLE  
knob: align the notch on the knob with the number or symbol  
representing the desired wash cycle. The START/PAUSE  
indicator light will go on.  
Based on how soiled the items are, the amount can be  
adjusted to individual cases using powder or liquid  
detergent.  
In the case of normally soiled items, use approximately  
either 35 gr (powder detergent) or 35 ml (liquid detergent).  
If tablets are used, one tablet will be enough.  
6. Select the wash options* (see Options and Special Wash  
If the crockery is only lightly soiled or if it has been rinsed  
with water before being placed in the dishwasher, reduce  
the amount of detergent used accordingly.  
Cycles).  
7. Start the cycle by pressing the START button; the indicator  
light will stop flashing and stay lit (fixed light). The indicator light  
corresponding to the wash phase will go on, signalling that the  
wash cycle has begun.  
8. At the end of the wash cycle the END indicator light will go on  
(fixed light). Switch off the appliance by pressing the ON/OFF  
button, shut off the water tap and unplug the appliance from  
the electricity socket.  
For good washing results also follow the instructions shown  
on the detergent box.  
For further questions please ask the detergent producers'  
Advice Offices.  
To open the detergent dispenser use the opening device “A”.  
9. Wait a few minutes before removing the crockery to avoid  
getting burnt. Unload the racks, beginning with the lower level.  
- The machine will switch off automatically during long  
periods of inactivity in order to minimise electricity  
consumption.  
AUTO WASH CYCLES*: some models of dishwasher are  
equipped with a special sensor which can be used to assess  
the level of soiling and automatically select the most efficient  
and economic wash cycle accordingly. The duration of the auto  
wash cycles may vary due to the operation of the sensor.  
Introduce the detergent into the dry dispenser “B” only.  
Place the amount of detergent for pre-washing directly  
inside the tub.  
Changing a wash cycle in progress  
If a mistake was made in the wash-cycle selection process, it is  
possible to change the cycle provided that it has only just begun:  
once the wash cycle has started, in order to change the wash  
cycle switch off the machine by pressing and holding the ON/  
OFF/Reset button. Switch it back on using the same button and  
select the desired wash cycle and options.  
1. When measuring out the detergent refer to the Table of wash  
cycles to add the proper quantity. Compartment B comprises  
a level showing the maximum quantity of liquid or powder  
detergent that can be added to each cycle.  
2. Remove detergent residues from the edges of the dispenser  
and close the cover until it clicks.  
Adding extra crockery  
3. Close the lid of the detergent dispenser by pulling it up until  
the closing device is secured in place.  
The detergent dispenser automatically opens up at the right time  
according to the wash cycle.  
Press the Start/Pause button and open the door, taking care to  
avoid the escaping steam, and place the crockery inside the  
dishwasher. Press the Start/Pause button: The cycle will start  
again after a long beep has been emitted.  
If all-in-one detergents are used, we recommend using the TABS  
option, because it adjusts the cycle so that the best washing  
and drying results are always achieved.  
If the delayed start has been set, at the end of the countdown  
the wash cycle will not start. It will stay in Pause mode.  
Only use detergent which has been specifically designed  
for dishwashers.  
Press the Start/Pause button to pause the machine; the wash  
cycle is stopped.  
At this stage the wash cycle cannot be changed.  
DO NOT USE washing-up liquid.  
Using excessive detergent may result in foam residue  
remaining in the machine after the cycle has ended.  
Accidental interruptions  
If the door is opened during the wash cycle or there is a power  
cut, the cycle stops. It starts again from the point at which it  
was interrupted once the door has been shut or the electricity  
supply restored.  
The use of tablets is only recommended for models which  
offer the MULTI-FUNCTIONAL TABLETS option.  
To achieve the best results from each washing and drying  
cycle, powder detergent, liquid rinse aid and salt should  
be used.  
* Only available in selected models.  
9
GeneralDetails
Nameindesit DFG 15B1 Built Dishwasher
MakeINDESIT
LanguageEnglish
FiletypePDF (Download)
File size2.71 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
INDESIT D2I HL326 Full Size Dishwasher
INDESIT D2I HL326 Full Size Dishwasher
Indesit D2F HD624 A Separate Dishwasher
Indesit D2F HD624 A Separate Dishwasher
Indesit 869991713220 Dishwasher
Indesit 869991713220 Dishwasher
INDESIT I0F D641A X Free Standing Dishwasher
INDESIT I0F D641A X Free Standing Dishwasher
Indesit I0F D641A Dishwasher
Indesit I0F D641A Dishwasher
INDESIT DFE 1B19 14 Dishwasher
INDESIT DFE 1B19 14 Dishwasher
INDeSIT D2F Dishwasher
INDeSIT D2F Dishwasher
INDeSIT D2I HD524 A Dishwasher
INDeSIT D2I HD524 A Dishwasher
INDESIT W11667630 B Dishwasher
INDESIT W11667630 B Dishwasher
InDeSIT IN2FE10CS90S Dishwasher
InDeSIT IN2FE10CS90S Dishwasher

indesit DFG 15B1 Built Dishwasher