indesit DFG 15B1 Built Dishwasher
Troubleshooting
Whenever the appliance fails to work, check for a solution from the following list before calling for Assistance.
EN
Problem:
Possible causes / solutions:
The dishwasher cannot be started or • Switch off the appliance by pressing the ON/OFF button. Switch it back on
controlled.
after approximately one minute and reset the program.
• The appliance has not been plugged in properly.
• The dishwasher door has not been shut properly.
• The lock was released. Strongly push the door until a “clacking” noise is
heard.
The door won’t close.
No water drains from the
dishwasher.
• The dishwasher cycle has not finished yet.
• The water drain hose is bent (see Installation).
• The drain duct is blocked.
• The filter is clogged up with food residues.
The dishwasher is too noisy.
• The dishes are rattling against each other or against the sprayer arms.
• An excessive amount of foam has been produced: the detergent has not been
measured out correctly or it is not suitable for use in dishwashers (see Start-
up and use).
The dishes and glasses are
covered in a white film or
limescale deposits.
• The level of refined salt is low or the dosage setting is not suited to the
hardness of the water (see Rinse aid and salt).
• The lid on the salt dispenser was not closed properly.
• The rinse aid has been used up or the dosage is too low.
The dishes and glasses are
streaked or have a bluish
tinge.
• The rinse aid dosage is too high.
The crockery has not been
dried properly.
• A wash cycle without a drying cycle has been selected.
• The rinse aid has been used up or the dosage is too low (see Rinse aid and
salt).
• The rinse aid setting is not suitable.
• The crockery is made from non-stick material or plastic.
The crockery is not clean.
• The racks are overloaded (see Loading the racks.)
• The crockery has not been arranged properly.
• The sprayer arms cannot move freely.
• The wash cycle is too gentle (see Wash cycles).
• An excessive amount of foam has been produced: the detergent has not been
measured out correctly or it is not suitable for use in dishwashers (see Start-
up and use).
• The lid on the rinse aid compartment was not shut correctly.
• The filter is dirty or blocked (see Care and maintenance).
• The refined salt level is low (see Rinse aid and salt).
The dishwasher does not take
any water in - Tap shut-off
alarm.
• There is no water in the mains supply.
• The water inlet hose is bent (see Installation).
• Turn on the tap and the appliance will start after a few minutes.
• The appliance stopped because no action was taken when the beep
sounded*. (*Only available on selected models.)
(The Drying and End indicator lights
flash quickly.)
Switch off the machine using the ON/OFF button, turn on the tap and switch
the machine back on after 20 seconds by pressing the same button. Reset the
appliance and restart the wash cycle.
* Only available in selected models.
13
| General | Details |
|---|---|
| Name | indesit DFG 15B1 Built Dishwasher |
| Make | INDESIT |
| Language | English |
| Filetype | PDF (Download) |
| File size | 2.71 MB |
(1 votes, average: 5.00 out of 5)
Loading...
INDESIT D2I HL326 Full Size Dishwasher
Indesit D2F HD624 A Separate Dishwasher
Indesit 869991713220 Dishwasher
INDESIT I0F D641A X Free Standing Dishwasher
Indesit I0F D641A Dishwasher
INDESIT DFE 1B19 14 Dishwasher
INDeSIT D2F Dishwasher
INDeSIT D2I HD524 A Dishwasher
INDESIT W11667630 B Dishwasher
InDeSIT IN2FE10CS90S Dishwasher
TOSHIBA DW-08T1 Place Setting Dishwasher
Centerline CDH ML-130374 Commercial Dishwasher
seasons SDW2FCMW Front Dishwasher
JennAir QQSCHIB Dishwasher
BOSCH SPV6YMX11E Dishwasher
Whirlpool FB4Y7S Dishwasher
FISHER AND PAYKEL DD24STX6I Tall Dishwasher
FISHER and PAYKEL DW60FC1B2 Sanitise Dishwasher
BOSCH SMS4HMC65M Dishwasher
SIEMENS SN61IX12TG Dishwasher