SHARP QW-NA24S42DI-EE Dishwasher
Continued use of too much detergent may
cause machine damage.
Using little detergent can result in poor
cleaning and you can see whitish streaksin
hard water.
washed clean.
If rinse aid dosage setting set too height,
you can see bluish layers on glass and
dishes.
4.12. Filling the rinse-aid and setting
See the detergent manufacturer’s
instructions for a further information.
To fill the rinse aid compartment, open
the rinse-aid compartment cap. Fill the
compartment with rinse aid to the MAX level
and then close the cap. Be careful not to
overfill the rinse aid compartment and wipe
up any spills.
4.9. Filling the detergent
Push the latch to open the dispenser and
pour in the detergent.
Close the lid and press it until it locks in
place. The dispenser should be refilled just
before the start of each programme. If the
dishes are heavily soiled, place additional
detergent in the pre-wash detergent
In order to change the rinse aid level,
follow the below steps before turning on
the machine:
chamber.
•
Turn on the machine by pressing the
On/Off button.
•
Press the Programme button for at
least 5 seconds immediately after the
machine is turned on.
DETERGENT
•
Release the Programme button when
“rA” is shown. Rinse aid level setting
follows water hardness level setting.
Next, the last setting level is displayed.
•
•
•
Set the level by pushing the programme
button.
4.10. Using combined detergents
These products should be used according
to the manufacturer’s instructions.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the combination.
Switch off the machine to save the
setting.
The factory setting is “4”.
If the dishes are not drying properly or are
spotted, increase the level. If blue stains
form on your dishes, decrease the level.
We recommend you do not use combined
detergents in short programmes.
Please use powder detergents in such
programmes.
If you encounter problems when using
combined detergents, please contact the
detergent manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to the correct level.
4.11. Rinse-aid usage
The rinse aid helps to dry the dishes without
streaks and stains. Rinse-aid is required for
stain-free utensils and clear glasses. The
rinse aid is automatically released during
the hot rinse phase. If rinse aid dosage
setting set too low, whitish stains remains
on dishes and dishes do not dry and
EN - 11
| General | Details |
|---|---|
| Name | SHARP QW-NA24S42DI-EE Dishwasher |
| Make | Sharp |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1.04 MB |
(1 votes, average: 5.00 out of 5)
Loading...
SHARP SDW6506JS 24 Front Dishwasher
SHARP SDW6888JS Smart Dishwasher
SHARP QW-NA1BF47EI-EU Series Dishwasher
SHARP SDW6767HS Dishwasher
SHARP SDW6767HS Slide In Smart Dishwasher
SHARP SDW6767HS Smart Dishwasher
SHARP QW-NA26F39DI-EN Dishwasher
SHARP QW-NS1CF49EI-ES Dishwasher
SHARP SDW6757ES Dishwasher
SHARP QW-NA25GU44BS-DE Undercounter Dishwasher
AEG FSE94848P Sliding Door Dishwasher
IKEA 304.754.26 LAGAN Integrated Dishwasher
BOSCH SMS8ZCI00X Dishwasher
FISHER PAYKEL DD24SDFTX9 N Dishwasher
FISHER and PAYKEL DD60SCTX9 Dishwasher
FISHER and PAYKEL DD60DDFHX9 Dishwasher
Whirlpool W11049299A Dishwasher
FISHER & PAYKEL DW60UNT4X2 Built-Under Dishwasher
FRIGIDAIRE FDPC4221AS Dishwasher
lord D5 Dishwasher