Home > HOBART > HOBART CLCS66e ML Series Dishwasher

HOBART CLCS66e ML Series Dishwasher

OPERATION  
PREPARATION  
LATCH  
END CAPS  
Make sure the dishwasher is clean  
and all parts are in place.  
PREWASH ARM  
IfEquippedwithScrapper(PS/CS)  
STANDPIPE  
GUIDE  
Install the standpipe in the scrapper  
tank(Fig.21). Standpipewithstrainer  
(Fig. 21) goes in the first tank where  
the rack enters the machine.  
CONNECTOR PIPE  
Install the rear and side strainer pans  
and lower the strainer bucket (Fig. 23).  
Fig. 22  
Fig. 21  
STRAINER  
PANS  
CONNECTOR  
PIPE  
Install the upper wash arm (Fig. 22) and the lower wash arm  
(Fig. 23) in the scrapper with all end caps. Push arm onto the  
connector pipe so the opposite end is held by the guide; then  
lift or lower into position.  
GUIDE  
STRAINER  
BUCKET  
PREWASH ARM  
Wash / Rinse Tanks  
Fig. 23  
Install the standpipe(s) in the tank(s) (Figs. 21  
and / or 24). Standpipe without strainer (Fig.  
24) goes in second / third tank.  
LATCH  
END  
Install the strainer pan and the strainer bucket  
(Fig. 26).  
GUIDE  
CAPS  
Install the upper wash arm (Fig. 25) and  
the lower wash arm (Fig. 26) with all end  
caps. Push arm onto the connector pipe  
so the opposite end is held by the guide  
(Figs. 25, 26); then lift or lower into position.  
WASH ARM  
CONNECTOR  
PIPE  
Fig. 24  
Fig. 25  
CONNECTOR PIPE  
Curtains & Doors  
GUIDE  
Hang all curtains according to the appropriate curtain diagram  
(pages 21 – 23).  
Close all doors: This lowers and seats the standpipe(s).  
STRAINER  
PAN  
WASH ARM  
STRAINER  
BUCKET  
END CAPS  
Fig. 26  
– 21 –  
GeneralDetails
NameHOBART CLCS66e ML Series Dishwasher
MakeHOBART
LanguageEnglish
FiletypePDF (Download)
File size2.18 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
HOBART AM16 Commercial Dishwasher
HOBART AM16 Commercial Dishwasher
HOBART S.48820 Commercial Dishwasher
HOBART S.48820 Commercial Dishwasher

HOBART CLCS66e ML Series Dishwasher